|
 |
| |
Our copper pool panels are a better choice than plastic
planels. Sun Ray Solar panels are heat exchangers specifically
engineered to absorb solar energy. It is not just a black plastic
garden hose or floor mat.
Sun Ray's metallic Pool Panels are superior in heat conductivity, heat
transfer and durability. Sun Ray Solar copper tubing waterways are stronger
than plastic. The panels resist higher pressure and are not subject to
punctures, fire or high stagnation temperature. The material will not break
down with prolonged exposure to the sun.
In order to achieve any degree of performance, plastic panels must be constructed
with a large number of tightly spaced thin-walled tubing. Obviously thin
wall plastic tubing is far less durable then copper pipe, especially when
exposed to the harsh environment of the sun.
The panels are strong and self-supporting. No solid sheeting under the
panels are required, therefore reducing the cost of ground mount installation.
The panels can be repaired by simple soldering if required.
The panels can be repainted for a fresh look if required.
Sun Ray pool panels are lightweight. Less then one pound per square foot.
The panels will stand a stagnation temperature of up to 250° F therefore
they can be installed glazed (glass covered) or unglazed. |
| |
| |
| |
| |
Most swimming pools are permanent. So why not a permanent pool heating
system?
A slightly higher initial cost and technical skill is required to install
a copper system but quality always cost less it the long run.
The standard pool panel sizes are 4'x8', 4'x10' and 4'x12'. However,
we can make custom sized panels to fit your area at no extra charge.
Sun Ray pool panels are made of a number of roll formed copper aluminum
fin-tubes spaced 4 ¼” apart or
less. The absorbing fin sections are mechanically bonded 360° around
a ½”
OD seamless copper flow tubing and crimped on its horizontal axes for
maximum heat transfer. The absorbing fin thickness is .012" pre
painted aluminum. The fin-tubes are brazed to 1 ½” copper
headers.
All parts of the panels that have direct contact with pool water are
copper.
The panels are coated black by professional metal finishers. The metal
is etched, washed, painted and backed for efficiency, durability and
a superior look.
The panels will stand a stagnation temperature of up to 250° F. Each
panel is pressure tested at 100 PSI.
For a pleasing esthetic look, the panels are installed with no gaps between
them and will look great wherever you place them. The panels overlap each other the same way each individual fin does.
The panels can be crated and shipped directly from our manufacturing facility to any jobsite.
Installation Instructions for Pool Heating System |
| |
| |
|
|
